Home > Ampeg B15NC Project > Wiring progress

Wiring progress

November 7th, 2009 Leave a comment Go to comments

Well, it’s been awhile but I have finally made a little more progress on the wiring.  Besides taking time off to work on a couple of other projects, I also had to get more Teflon wire.  While I had plenty of wire here to do this project, I did not have much of a variety of colors.  As I got deeper into this project I began to realize that there was a logic (duh!) to the wire colors used in the original amps.  In hindsight this seems rather obvious, but as I’ve mentioned before, this is all new to me, and sometimes there are details just staring me in the face that I initially don’t catch.  That is the major point of this project though, so I am continuing to learn.

Continuing to wire the board

Continuing to wire the board

 

I am trying to get as much wiring done to the board as I can before I install it in the chassis.  I am trying to only do wires that make sense right now.  Others, such as some of the control leads, I think will be easier to do after the board is installed.

Categories: Ampeg B15NC Project Tags:
  1. No comments yet.
  1. No trackbacks yet.